Chinese | Substation | Sitemap | RSS | XML

Welcome to Fuermeng Precision Mould Factory

Precision stamping parts

通用banner
Your current location : Home >> News >> Frequently asked questions

Precautions in installation of Kunshan mold processing and sharing belt tension tester

2019-11-13

In the process of installation of Kunshan mold processing and sharing belt tension tester, attention should be paid.

During the installation of the electronic tension tester, the following aspects should be paid attention to: 1. It should be installed in a clean, dry and even temperature house. At the same time, the possibility of making a long beam bending test on the machine and the possibility of using a mirror extensometer for the test should be considered. Therefore, sufficient space should be reserved around the tester Free area of.

2. During the installation of electronic tensile testing machine body and dynamometer, the general foundation shall be made according to the foundation drawing and the anchor screw hole shall be reserved for casting.

3. To find the level of the main body of the testing machine, place the level meter on the outer circle of the oil cylinder to find the level according to the vertical and horizontal positions of the machine base and the horizontal direction. Use the level meter with an accuracy of 0.10/1000mm to find ± 1 grid. If not, add sizing block under the base to adjust.

4. There are two holes on the top of the dynamometer for steel wire rope during re installation.


Kunshan mold processing

5. The level of the dynamometer is very important. When leveling, align the left side of the swing bar with the scribe line of the standard line plate, so that it does not move. Then use the bending rule to lean against the large surface of the upper part of the swing bar and place the 0.1/1000mm level on the bending rule to find ± 2 grids. When it is not right, add sizing block under the base, and make sure that both the pendulum and the non hanging pendulum are aligned with the zero point.

6. The electronic tension tester will open the iron door on the back of the dynamometer to check whether the wire of the small wire hammer is wound in the groove of the pointer coaxial pinion. The length of the tying rope should be appropriate, not too long or too short, and its limit is that it can't touch the diaphragm plate at the longest, and the shortest is that the small gear wheel rotates for one cycle, and the aging hammer won't touch the pinion.

When installing the electronic tension tester, attention should be paid to the details, especially to the mutual connection of various parts. In addition, before the installation of the electronic tension tester, the installation skills should be carefully understood.


Label

Recently Viewed:

  • Phone+86 512-55199976
  • Fax+86 512-55199972
  • Mailboxyimeng188@163.com
  • AddressKunshan City International Mould City Material Zone E12-4
Kunshan Yushan Fuermeng Precision Mould Factory  all rights reserved. Technical Support:Xiangyun platform Service support:

       QQ截图20191213184113.jpg